AMD NOVELL 64 Instalační příručka stáhnout pdf (Strana 27)

Installing Identity Manager 27

Pre-Installation Summary: Review the Pre-Installation summary page, which contains

information about the selected components. To change any of these settings, click Previous.

Installation Complete Summary: Review the post-installation summary to verify the

installation status of the selected components and the location of the log file for each component.

See Table 4-2 on page 35 for information about the location of the log files.

Continue for Configuration: (Conditional) This check box is enabled only when the selected

components are configurable. If you want to continue with configuration, continue with

Section 4.2.2, “Configuration,” on page 27. If you don’t want to continue with the configuration,

deselect this check box.

4.2.2 Configuration

You can configure the Identity Manager components that you have already installed by using the

integrated installer. Verify you have completed Section 4.2.1, “Installation,” on page 26 before

preceding with the configuration.

IMPORTANT: When you are create a new tree or add to an existing tree, if the

/etc/hosts

file

contains 127.0.0.2 entry, the configuration fails because default IP certificate is created for the

127.0.0.2 loopback address. For a successful configuration, comment the 127.0.0.2 loopback address

and make sure that 127.0.0.1 loopback address and the real IP address is in the file.

To configure the Identity Manager components:

1 If you are continuing from Step 3 on page 26 in the installation procedure, skip to Step 2.

Otherwise, start the configuration with the correct program for your platform:

Linux:

./configure.bin

Solaris:

./configure.bin

To execute the binary file, enter

./configure.bin.

Windows:

configure.exe

2 Select the components you want to configure, click Next.

3 Select one of the following options to complete the configuration of the Identity Manager

components:

 “Creating a New Tree” on page 28

 “Adding to an Existing Tree” on page 32

You must take a note of the following information before proceeding with the configuration of

Identity Manager components:

 If you are adding to an existing tree, run the NrfCaseUpdate utility on the primary server

to support mixed-case searching on roles and resources if the primary server has Identity

Manager 3.6 or above.

If you don’t run the NrfCaseUpdate utility, Metadirectory server configuration fails. For

more information on running the NrfCaseUpdate utility, see “Running the NrfCaseUpdate

Utility” in the Identity Manager Roles Based Provisioning Module 4.0.1 User Application:

Installation Guide.

 The integrated installer does not perform a health check before the secondary server

addition. You must run ndscheck before adding secondary server through integrated

installer. On Windows, run the ndscheck from the

<install location>\NDS

location. On

Linux/Solaris, run it from the

/opt/novell/eDirectory/bin/ndscheck

directory. Specify

the madatory parameters and run the command as follows:

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Komentáře k této Příručce

Žádné komentáře

AMD NOVELL 64 Instalační příručka Strana 27

Komentáře k této Příručce