AMD LE-363 User's Uživatelská příručka stáhnout pdf (Strana 175)

100

101

Chapter 8 Virtual Host Bus Adapters (vHBAs) 149

▼ Bind After prescan

The ideal scenario is to bind the prescan-discovery results to a host server. XgOS

supports binding the server profile with the phys-con after a prescan is complete, as

long as you follow the correct configuration order.

Follow these steps to perform a prescan then bind the server profile:

1. Create an unbound server profile:

2. Create a vHBA under this unbound server:

3. Set this vHBA to prescan state:

4. Display the targets:

From now on if there are any RSCN changes, the targets will also be updated

accordingly.

Note – At this point, you can also specify the target order by integrating persistent

mapping with prescan. See “Persistent Binding” on page 142. If you do, be sure to

issue remove-prescan before binding.

wwpn 50:01:39:70:00:00:F1:02

map

lun-mask

local-id 0

------------------------------------------------------------------------

1 record displayed

add server-profile III

add vhba vhbaiii.III 4/1

set vhba vhbaiii.III prescan

show vhba vhbaiii.III targets

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 435 436

Komentáře k této Příručce

Žádné komentáře

AMD LE-363 User's Uživatelská příručka Strana 175

Komentáře k této Příručce